Products Internet About Support Home Page
This Router product is an add-on function to Symdriver-T. It allows the routing of TCP/IP traffic as an integral Windows NT service. It also allows the user to configure for RAS (Remote Access Service) functionality. It is supplied with a manual and is packaged on a single 3.5" floppy disk. 
  • About Symrouter-T 
Symrouter-T is a service that allows you to use TCP/IP protocol to connect to remote IP nodes across a Wide Area Network. Symrouter-T offers full RFC 887/1536 compliance and a maximum of 100 routes or connections. Symrouter-T also offers dynamic calling and call clearing along with an activity timer which will clear inactive connections and automatically re-establish the connection when the respective route becomes active again. 
  • About Symrouter-T (RAS) 
 
Symrouter-T(RAS) is an installable Windows NT device driver that uses the capabilities of a DTSX adapter for Point-to-Point Protocol connectivity via leased line or ISDN. Symrouter-T(RAS) utilises the facilities of Symdriver-T to give ISDN connectivity to the Remote Access Service. The Remote Access Service allows geographically remote users to connect to a central site giving access to that site as if the remote user were actually logging on locally or directly attached to the system. 
 
  • System Requirements 
 
An x86-based microprocessor (such as Intel 80486/25 or higher), Intel Pentium, or other    supported processor 
VGA or higher resolution monitor 
One or more hard disks and a 3.5-inch disk drive 
12Mb of RAM (16Mb recommended) 
Windows NT 3.51 operating system or later installed. 
Symdriver-T installed 
A Symicron DTSX adapter card 
Mouse or other pointing device. 
 
 
 		 Symrouter-T  
  •  RFC 1536 compliant device 
  • 100 Routes or Connections 
  • Dynamic calling and call-clearing 
  • Line Inactivity timer 
  • Dual operation, either X.25 only or X.25 over ISDN 
 
Symrouter-T(RAS)  
  •  Remote access service (RAS/TAPI) support 
  • Synchronous PPP over ISDN only 
  • Raw HDLC support 
  • Full Symdriver-T functionality          enabling use of API’s on Non-RAS ports. 
  • Static port selection (RAS associated with DTSX port at start-up) 
  • Dialback support 
 
 
Copyright Symicron Computer Communications Limited ©2000